The most important option in nf is nameserver, which gives the IP-address of a name server to use. If your are on a local network and have the opportunity to use an existing nameserver, this should always be preferred. If you run a name server on your local host, you have to set it up separately, as will be explained in the following section. This means that on a host running a name server, you should create a zero-length /etc/nf file,Įven if you don't intend to put any directives in it. If this file does not exist or is empty, the resolver assumes the name server is on your local host. There is a separate file for this, called nf. You also have to tell it which name servers to use. When configuring the resolver library to use the BIND name service for host lookups, The binding order determines the order in which the operating system runs the protocol. If we have a mix of adapters and protocols, Over a driver, we define some protocols, rules and procedures for communicating. TX packets 463324 bytes 491077760 (491.0 MB)Ĭommand ncpa.cpl opens a GUI list of adaptersĪ network adapter requires a device driver, the software that enables a computer RX errors 0 dropped 227 overruns 0 frame 0 TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
0 kommentar(er)
